Rice Lake Motorola DS457 Laser Scanner - Manual (Page 107)

Imager Preferences 7 - 13
Snapshot Mode Timeout
Parameter # F0h 43h
This parameter sets the amount of time the imager remains in Snapshot Mode. The imager exits Snapshot
Mode upon a trigger event, or when the Snapshot Mode Timeout elapses. To set this timeout value, scan the
bar code below followed by a bar code from
Appendix D, Numeric Bar Codes
. The default value is 0 which
represents 30 seconds; values increment by 30. For example, 1 = 60 seconds, 2 = 90 seconds, etc.
Snapshot Aiming Pattern
Parameter # F0h 2Ch
Select
Enable Snapshot Aiming Pattern
to project the aiming pattern when in Snapshot Mode, or
Disable
Snapshot Aiming Pattern
to turn the aiming pattern off.
Snapshot Mode Timeout
*Enable Snapshot Aiming Pattern
(01h)
Disable Snapshot Aiming Pattern
(00h)