Rice Lake Motorola DS457 Laser Scanner - Manual (Page 67)

User Preferences 6 - 5
User Preferences
Set Default Parameter
You can reset the DS457 to two types of defaults: factory defaults or custom defaults. Scan the appropriate bar
code below to reset the imager to its default settings and/or set its current settings as custom defaults.
• Restore Defaults
- Scan this bar code to reset all default parameters as follows.
•
If you previously set custom defaults by scanning
Write to Custom Defaults
, scan
Restore Defaults
to retrieve and restore the imager’s custom default settings.
•
If you did not set custom defaults, scan
Restore Defaults
to restore the factory default values listed in
Table A-1
.
• Set Factory Defaults
- Scan this bar code to restore the factory default values listed in
Table A-1.
This
deletes any custom defaults set.
• Write to Custom Defaults
- Scan this bar code to set the current imager settings as custom defaults.
Once set, you can recover custom default settings by scanning
Restore Defaults
.
*Restore Defaults
Set Factory Defaults
Write to Custom Defaults