Rice Lake Motorola DS457 Laser Scanner - Manual (Page 77)

User Preferences 6 - 15
Power Mode (RS-232 Hosts Only)
Parameter # 80h
Select whether or not the imager enters Low Power consumption mode after a decode attempt. In Continuous
On mode, the imager does not enter this low power state.
Time Delay to Low Power Mode
Parameter # 92h
This parameter sets the time the imager remains active after decoding. After a scan session, the imager waits
this amount of time before entering Low Power mode.
Continuous On
(00h)
*Low Power Mode
(01h)
NOTE
This parameter only applies when
Power Mode
is set to
Low Power
.
To program a different value for this parameter than those provided here, see
Using Time Delay to Low
Power Mode with SSI on page 8-7
.
*1 Second
(11h)
5 Seconds
(15h)