Hearth and Home Technologies I60 - Manual (Page 22)

22
• Remove smoke shield by removing fi ve screws. See
Figure 7.3. Smoke shield is located at top of fi replace
front.
Figure 7.5 Shipping Spacers
Figure 7.4 Removing the Screen Rods
Front Face
Smoke Shield
Remove these screws.
Skip Skip
Figure 7.3 Removing Smoke Shield
• Remove hearth stone by removing three corrugated
shipping spacers (Figure 7.5). Lift hearth stone out of
fi replace. See Figure 7.6.
Figure 7.6 Lifting Out the Hearth Stone
WARNING! Risk of Fire! Prevent contact with sagging,
loose insulation.
• DO NOT install against vapor barriers or exposed
insulation.
• Secure insulation and vapor barriers.
• Provide minimum air space clearances at the sides
and back of the fireplace assembly as outlined in
Section 6.
Figure 7.7 Removing Shipping Brackets
Note: Before installing refractories and hearth stone, be
sure all back edges of each piece are smooth to ensure
proper fi t.
Scrape away excess with a regular screwdriver. See
Figure 7.8.
Figure 7.8 Scrape Away Rough Edges
• Place the fi replace on a continuous fl at surface.
• Follow framing instructions in Section 6.
• Slide
fi replace into position (brackets can be used to
anchor fi replace in position).
• Remove screens by removing screw from the end of
each screen rod. See Figure 7.4.
E. Position the Fireplace (I80 only)
• Remove fi replace from pallet.
The
fi replace is attached to pallet with two brackets on
each side and rear of outer shell. See Figure 7.7.
• Remove screws from bracket, pallet and fireplace.
Replace screws removed from fi replace.
Heatilator • I60, I80 • 4013-250 • Rev C • 11/08