FMI MASONRY FIREBOX MM33 - Manual (Page 3)

www.fmiproducts.com 125160-01A 3
saFety
Continued
WaRnInG: THIs FIRePlaCe Has noT Been
TesTed FoR Use WITH an UnVenTed Gas
loG seT. To RedUCe THe RIsK oF FIRe oR
InJURY, do noT InsTall an UnVenTed Gas
loG seT InTo FIRePlaCe.
WaRnInG: THIs FIRePlaCe Has Been
TesTed FoR Use WITH oPTIonal Glass
dooRs FRoM CRoWn-BReCKInRIdGe oR
MCKenZIe-PendelTon onlY.
GUIdelInes FoR Use:
All current and future users of FMI PRODUCTS, LLC
Fireplaces are charged with the responsibility for full
knowledge of the information contained within this
manual which includes:
Strict requirements for assembly.
Detailed instructions for installation.
Cautionary guidelines for use.
On-going maintenance instructions.
It is the responsibility of the distributor, subcontractor
and/or the general contractor – whoever shoulders
the liability for installation of this product – to see that
it works in complete compliance with the guidelines
and instructions in this manual. Note that the general
contractor is the party accountable for seeing that
adequate clearances are provided for all firebox
surfaces per specifications in this manual.
The Grand Meridian is designed for Use only
with:
- Solid Wood Logs
- Plumbed LPG or Natural Gas Log Lighter.
- Plumbed ANSI Z21.60 or Z21.84 Decorative Gas
Log.
do noT Use oR sToRe GasolIne oR oTHeR
FlaMMaBle lIQUIds oR Gases In oR neaR
THe FIRePlaCe!
aTTenTIon: A fire or an explosion could occur
causing property damage, injury or loss of life if you
do not follow the information in this manual!
noTe: THIS MANUAL MUST BE REPRODUCED
ONLY IN ITS ENTIRETY.
Before Beginning the Installation
Read these instructions carefully before beginning
the installation of this fireplace. Also, if installing an
ANSI Z21.60 or Z21.84 Decorative Gas Log, read
the gas log appliance manufacturer’s literature
regarding sizing and suitability for the installation into
this enclosure prior to installation.
statement of Intended Use:
The Grand Meridian Fireplace is a modular refractory
masonry unit designed for field assembly. The firebox
is constructed using pre-cast, interlocking refractory
blocks. The blocks are then secured to each other
using Mortar. The system includes all parts necessary
for the assembly of a complete masonry fireplace.
In addition to the basic enclosure, a standard 1-1/8”
thick, high temperature refractory brick is required to
line the interior of the firebox and can be purchased
from the manufacturer.
These fireplaces are not intended to serve as
a primary heat source, rather, the fireplace was
expressly created as a supplemental source of heat.
The unit is designed for use with solid fuels such as
cord wood.
WaRnInG: any application other than the
“Intended Use” as stated above is in violation
of the manufacturer’s instructions and is hereby
prohibited. such violation may cause immediate
hazard, property damage or loss of life and will
void all liabilities to the manufacturer and will
void all warranties explicit or implied.