FUJITSU CM71-00329-7E - Manual (Page 118)

108
CHAPTER2 Dependence Functions
2.3.3 Commands Available during Execution of User Program
This section explains the commands available during the execution of a user program.
■ Commands Available during Execution of User Program
The emulator debugger (MB2198) allows you to use certain commands during the execution of a user
program.
For more details, refer to "
■ Supported Debuggers" in "SOFTUNE Workbench Command Reference
Manual".
The double circle indicates that it is available during the execution of a user program.
Table 2.3-2 shows the commands available during the execution of a user program.
*: For detail, refer to "2.3.4 Break".
Table 2.3-2 Commands Available during Execution of User Program
Function Restrictions Major Commands
MCU reset - 1.3 RESET
Memory operation
(Read/Write)
1. Emulation memory only operable Read only
enabled in real-time monitoring area.
2. When Real-time monitor mode, it is not possible
to read/write it excluding a real-time area.
3. Not possible when the DSU3 evaluation chip is used.
5.1 EXAMINE
5.2 ENTER
5.3 SET MEMORY
5.4 SHOW MEMORY
5.5 SEARCH MEMORY
5.8 COMPARE
5.9 FILL
5.10 MOVE
5.11 DUMP
Line assembly, Disassembly 1. Emulation memory only enabled Real-time
monitoring area, Disassembly only enabled
2. Not possible when the DSU3 evaluation chip is used.
6.1 ASSEMBLE
6.2 DISASSEMBLE
Break Point Settings Oprable only when "Breakpoint Settings during
Execution" is enabled in the execution tab of the
debug environment set dialog.( *)
3.1 SET BREAK (type 1)
3.4 SET BREAK (type 4)
3.6 CANCEL BREAK
3.7 ENABLE BREAK
3.8 DISABLE BREAK
3.10 SET DATABREAK (type 2)
3.12 CANCEL DATABREAK
3.13 ENABLE DATABREAK
3.14 DISABLE DATABREAK