FUJITSU CM71-00329-7E - Manual (Page 161)

151
CHAPTER2 Dependence Functions
2.4.1 Starting debugging
This section describes the method of starting debugging.
■ Starting Debugging
When starting debugging, select the [Debug] - [Start debug] menu. When debugging is started by a new
project, the setup wizard for performing initial setting is activated. For details, refer to "4.7.2.5 Setup
Wizard" in "SOFTUNE Workbench Operation Manual".
■ Verification Items When Starting Debugging
When starting debugging, perform checking for initial settings. When an item of initial setting is not
correct, debugging cannot be started.
• DEBUG I/F
Verify whether the DEBUG I/F is enabled or effective.
For details, refer to "2.4.1.1 Power-on Reset".
• Operating environments of the target
Verify whether the operating environment of the target has a problem.
For details, refer to "2.4.1.2 Operating Environments of the Target".
• Security
Verify whether the security function has been enabled.
For details, refer to "2.4.1.3 Security".