FUJITSU CM71-00329-7E - Manual (Page 163)

153
CHAPTER2 Dependence Functions
2.4.1.2 Operating Environments of the Target
This section describes the setting of the target operating environments.
■ Operating Environments of the Target
In the emulator debugger (MB2100-01), it is necessary to set the following items according to the operating
environments of the target.
• Reference frequency of communication speed
• Length of DEBUG I/F cable
These settings influence the communication speed of the debugger.
●
Reference frequency of communication speed
Set main clock (MCLK).
The communication speed between emulator (MB2100-01) and the user system varies depending on the
main clock.
●
Length of DEBUG I/F cable
Specified the length of the cable that suits the length of DEBUG I/F cable.
The allowance maximum transfer rate from emulator (MB2100-01) to the direction of MCU changes
according to this length of the cable.
■ How to set
The setup wizard sets the operating environments of the target.
For details, refer to "4.7.2.5 Setup Wizard" in "SOFTUNE Workbench Operation Manual".
Figure 2.4-2 Setup Wizard (Communication Setting)