Frymaster GC User Manual
Page 22
4-2
4.2
Cleaning the Gas Valve Vent Tube
This procedure should be performed at least once every 90 days.
NOTE: This procedure is not required for cookers configured for export to CE
countries. The gas valves on CE units are not equipped with vent tubes.
1. Set the power switch and the gas valve to the OFF position.
2. Carefully unscrew the vent tube from the gas valve. NOTE: The vent tube may be straightened for
ease in removal.
3. Pass a piece of ordinary binding wire (.052 inch diameter) through the tube to remove any obstruction.
4. Remove the wire and blow through the tube to ensure it is clear.
5. Reinstall the tube and bend it so that the opening is pointing downward.
4.3
Cleaning and Adjusting the Combustion Air Blower
1. Unplug the cooker. Mark and disconnect the four wires running from the motor at the inline connectors.
2. Remove the four nuts and bolts securing the blower to mounting bracket. Remove the blower from the
cooker.
3. Remove the three fasteners that secure the blower motor assembly to the blower housing, and separate
the two components.
Remove these fasteners.
(On black-colored FASCO
blowers there are three
nuts. On silver-colored
KOOLTRONICS blowers
there are three screws.)