FARGO electronic II - Manual (Page 22)

17
2. The supply end of
the ribbon is the side
with the fresh, unused
ribbon on it. The
ribbon take-up is the
other end.
3.
Open the top-right
cover of the printer by
pressing its Cover
Release Button. Allow
the cover to swing up
and open.
4.
With the cover
open, place the supply
end of the ribbon in
between the two black
Ribbon Drive Hubs
located on the far right-
hand side of the
printerÕs interior. Make
certain that the ribbon
is fed from underneath
the ribbon roll. (Hint:
The Ribbon Drive Hub
nearest you, as you are
looking into the printer
from the front, is spring
loaded. Use the end of the
ribbon supply core to
push in this Ribbon
Drive Hub when
inserting the ribbon.)
Supply
Take-up
Follow these steps to load ribbon into the Printer:
1.
Remove the ribbon from its packaging. Do not
touch the colored portion of the ribbon. Oil or dirt
from your hands can impair print quality.
B. Loading
Ribbon into the
Printer
Take-up Ribbon
Drive Hubs
Supply Ribbon
Drive Hubs
Ribbon
Sensor