FARGO electronic II - Manual (Page 53)

2. Remove the ribbon and overlaminate rolls from the
printer.
3.
As you are looking inside the printer from the front,
locate the Internal Card Guide on the left-hand side (the
lamination side) of the printer. This guide straddles the
laminatorÕs black Drive Roller.
4. Remove the single screw from the two holes residing
to the immediate right of the laminatorÕs Internal Card
Guide.
5.
With your left hand, pull the laminatorÕs spring-
loaded Internal Card Guide toward you. If printing onto
cards which are over 2.3Ó in width, pull the Internal Card
Guide back behind the top-most hole (the hole furthest
from the front of the printer) and re-insert the screw into
this hole. Adjustment to the laminatorÕs Internal Card
Guide is now complete.
6. Now, locate the Internal Card Guide on the right-
hand side (the card input side) of the printer.
7. Remove the single screw from the two holes residing
to the immediate right of this Internal Card Guide.
8.
With your left hand, pull the spring-loaded Internal
Card Guide toward you. If printing onto cards which are
between 2.3Ó and 2.5Ó in width, pull the Internal Card
Guide back behind the top-most hole (the hole furthest
from the front of the printer) and re-insert the screw into
this hole.
9. If printing onto cards between 2.5Ó and 2.6Ó in width,
loosen the Internal Card GuideÕs mounting screws
(shown above), slide the Card Guide assembly all the
way toward the front of the printer, and retighten the
screws. Then, pull the Internal Card Guide back behind
the bottom-most hole (the hole closest to the front of the
printer) and re-insert the screw into this hole.
48
Internal
Card Guides
Card Guide Screws
Card Guide
Mounting Screws