FARGO electronic II - Manual (Page 29)

24
6. Close the cover. When you start to print, the
Lamination Drive Hubs will automatically engage
the notches on both cores of the overlaminate roll.
IMPORTANT!
5. Place the take-up
end of the roll in
between the two black
Lamination Drive
Hubs located on the
far left-hand side of
the printerÕs interior.
Load the take-up end
of the roll just as you
loaded the supply end
in step 4. When loaded
properly, the
overlaminate material
should feed
underneath both ends
of the overlaminate
roll.
Supply Roll
Take-up Roll
Do not reverse the overlaminate roll. Damage may occur
to the lamination roller!