FARGO electronic II - Manual (Page 44)

Lamination
Select this button to display options for controlling
the printerÕs lamination process. When the No
Lamination
option is selected, the printerÕs built-in
laminator will not be used. When using the
laminator, select from these options to choose the
card side(s) you would like to laminate or to select
the Lamination Type according to the overlaminate
material you currently have installed. In addition,
you can also select the Lamination Dwell Time or
through-put speed of a card in seconds/inch as
well as the Lamination Temperature. The default
settings for the Lamination Dwell Time and
Lamination Temperature should be accurate for
most card stocks and overlaminate types. See
Section 5 for more information on the printerÕs
lamination process.
IMPORTANT!
If you select the Film Lamination w/ Overlay option,
you must be using a ribbon which provides a clear
overlay panel. When used with this type of ribbon, the
printer will apply the clear overlay panel of the ribbon
over the film lamination layer of a printed card. This
process is required for maximizing card durability when
laminating with the thermal transfer film material. The
ribbon types which do not provide an overlay panel or
support overlay printing are Monochrome Resin and 5
Color, Resin Black. Avoid using these types of ribbons
in conjunction with the thermal transfer film material.
Selecting the printer driver’s standard Overlay option
forces the printer to automatically place the ribbon’s
clear overlay panel onto whichever side or sides of the
card you are printing. The Film Lamination w/
Overlay
option overrides the standard Overlay option
for the card’s laminated side only, forcing the printer to
place the ribbon’s clear overlay on top of the film
overlaminate rather than beneath it.
39