Fuji Bikes FEH381 - Manual (Page 105)

6-32 2. Main Menu Screen
Setting 2
*1 Network Table
Register IP addresses and other information for the UG230, PLCs or computers that should be included for
Ethernet communications on the UG00S-CW editor.
([System Setting]
→ [Network Table Setting] → [Ethernet] → Edit Network Table)
If you would like to use the IP address of the registered network table, select [IP Address from Network Table].
Cursor switches
Increment/Decrement switch for
the value in the cursor position
Determines the setting such as IP address,
and moves back to the Main Menu screen.
Used for checking the
10BASE-T interface.
Normal: Connect
Error: Disconnect
The Ethernet screen is displayed.
By pressing the [IP Address Setting] switch,
the desired IP address can be selected from
the network table.
The switch changes into [Select IP Address
from Network Table.].
*1
Network table
number