Fuji Bikes FEH381 - Manual (Page 84)

6
2. Main Menu Screen 6-11
P
O
D
O
per
at
io
ns
CN1 Test (with the option unit)
RS-232C signal test
Turn the [CN1] and [RS232C] switches on.
• SD/RD Test
Check the signals [SD] and [RD].
1. Install a jumper between pins 2 and 3 of CN1 on the backside of the UG230.
2. Press the [Self-Loop Test] switch. When the [OK] lamp lights up, the test is successfully
completed.
* If the [NG] lamp lights up, consult your local distributor.
• CTS/RTS Test
Check the signals [CTS] and [RTS].
1. Install a jumper between pins 4 (RTS) and 5 (CTS) of CN1 on the backside of the UG230.
2. Press the [RTS] switch and check that both [RTS] and [CTS] lamps light up at the same time.
Press the [RTS] switch again and check that both [RTS] and [CTS] lamps go off at the same
time.
CN1
MJ1
MJ2
RS232C
RS485
Communication Port
Self-Loop
Test
CTS RTS
NG OK
CTS RTS
NG OK
Self-Loop
Test
CTS RTS
NG OK
CTS RTS
NG OK
CTS RTS
NG OK
CTS RTS
NG OK
Self-Loop
Test
Self-Loop
Test
Self-Loop
Test
Self-Loop
Test