Fuji Bikes FEH381 - Manual (Page 51)

3
1. Mounting Procedure 3-1
Instal
lat
ion
1. Mounting Procedure
Mounting Procedure
1. Insert the UG230 into the mounting panel (max. thick: 5 mm).
2. Insert four fixtures attached to the UG230 into the mounting holes, and tighten them with the
locking screws.
Tightening Torque: 0.3 to 0.5 N•m
3. Mount the gasket so that it will be sandwiched securely between the unit and the mounting panel.
Mounting Angle
Install the unit within the angle of 0 ° to 135° as shown on the right.
Mounting panel
Panel cut-out hole
• Panel cut-out dimensions
(Unit: mm)
17.8
10.5
30.0
Fixture dimensions
(Unit: mm)
Fixtures
Mounting hole
Mounting hole
UG230
Mounting
panel
Fixtures
* To prevent static electricity, be sure to
connect the mounting panel to the ground.
0
°
135
°
90
°
Display
Dis
pla
y