Fuji Bikes FEH381 - Manual (Page 99)

6-26 2. Main Menu Screen
2-4. Messages during Data Transfer
If an error occurs during data transfer, the message
window shown on the right is displayed.
The kinds and the contents of the messages are shown below. The same messages are used for the
memory card and CF card. When using the CF card, the “memory card” in the explanation should
read as the “CF card”.
Message Contents
Work normally finished. The specified operation has been concluded normally.
Card recorder not connecting No card recorder is connected when selecting a modular jack.
UG00P-MR Communication Error
A communication error occurred between POD and UG00P-MR when
selecting a modular jack.
Card not setting Memory-Card not setting
Memory-Card Capacity over
Cannot write the data into a memory card because the data size in POD is
larger than the capacity of a memory card.
Write Protect: ON
Cannot write data into a memory card because the write protect switch in a
memory card is ON.
Writing Error occurred. The error occurred while writing data into a memory card.
Selected data does not exist. The data in the reading target does not exist.
UG type is different.
The specified type of the data in POD is different from the type of the memory
card data.
Selected data can not be read. The data in a memory card cannot be read.
Reading Error occurred. The error occurred during writing data into a flash ROM of POD.
Data discrepant
There is some discrepancy in data, when comparing data between a memory
card and POD.
Screen data on UG will be broken.
Warning about data destruction in POD that may occur when transferring the
font data larger than the present data from a memory card to POD.
(The [OK] switch continues transferring; the [Cancel] switch stops
transferring.)
Undefined Error occurred. The error occurred due to some cause other than mentioned above.