First Virtual Communications Voyager 3000 - Manual (Page 21)

Chapter Two
Installation and Setup
Unpacking and Initial Setup
On receipt of the system visually inspect the exterior of the packaging for any signs of
damage. If any damage is found the carrier and Eurologic must be notified immediately who
will advise you of the appropriate action. The cartons are sealed via packaging tape which
should be cut open in the normal manner. Remove the top foam layer from each box and
exercise caution when lifting out the components. At this point the contents should be verified
against the packing list and Eurologic should again be notified immediately if any
discrepancies exist. The devices and power supply units are packaged in anti-static packaging
and anti-static precautions must be observed prior to removal. The devices and power supply
units can now be inserted into the tower or shelf.
Prior to applying system power verify that the SCSI IDs are set up correctly as described in
Setting the SCSI IDs and that there is no conflict with any other devices on the SCSI bus.
Verify that the external cabling considerations have been met as described in Cabling and
termination issues.
Recommendations for installation of rackmount systems in
19” racks
It is essential that the following guidelines be complied with to ensure the safe and efficient
operation of VOYAGER 3000 rackmount computer equipment. Eurologic’s rackmount
systems may be installed in closed or open rackmount systems by observing the
environmental, electrical and mechanical precautions listed.
Ambient Temperature
Installation of rackmount systems in standard 19” cabinetry may lead to a differential between
the room ambient temperature and the internal ambient temperature of the rack environment.
The maximum operating temperature of the Voyager 3000 is 40 degrees centigrade, however
it is not recommended that the system is continuously run at these elevated temperatures.
Consideration should therefore be given to ensuring that the room ambient is compatible with
these specifications.
Air Flow
To ensure that the internal heat build up is adequately dissipated into the room environment,
air flow should in no way be restricted. It is essential that no vents or ducts are blocked, that
the system is a minimum of 1 metre away from a solid surface such as a wall or partition.
Airflow through the VOYAGER 3000 shelves is from front to rear.
Mechanical Loading
Consideration should be given to the loading of the cabinet. To maintain a low centre of
gravity (thus reducing the likelihood of instability) racks should be installed (where possible)
from the bottom of the cabinet upwards. This is essential to ensure personnel safety.