First Virtual Communications Voyager 3000 User Manual
Page 69
Front Panel Operation
5-5
5
To set the transfer mode, press t or s to select Set
Transfer Mode and press ENT
Set Transfer Rate
Mode ..
for 2 seconds
Press t or s to select the Sync or Async and press
ENT.
CHL=0
TransferMode=Sync
Change to=Async?
The controller must be reset (e.g., by powering-off then on again, by executing "Reset This
Controller" via LCD interface, etc.) for this to take effect.
6
To change the channel interface mode repeat Step 2
and 3, press t or s to select
Redefine Channel
Mode ..
Redefine Channel Mode and press ENT.
Press ENT for two seconds to change from host to
drive channel mode or vice versa.
The controller must be reset (e.g., by powering-off then on again, by executing "Reset This
Controller" via LCD interface, etc.) for this to take effect.
7
To delete a LUN definition repeat Step 2 and 3, press
t
or s to select View and
CHL=0 LUN=0
LG=0
Delete SCSI LUN and press ENT.
Press t or s to select the LUN number to be deleted
and press ENT.
Delete this LUN
Definition ?
To confirm deletion, press ENT for two seconds. To
cancel, press ESC.
Channel Terminator Setting
1 Press ENT for two seconds for the Main Menu.
2
Press t or s to select Set SCSI Channel Terminator
and press ENT.
Set SCSI Channel
Terminator ..
3
Press t or s to select channel and press ENT.
CHL=0 Terminator
Enabled
4
Press ENT for two seconds to change from enable to
disable or vice versa.
CHL=0 Disable
Terminator ?
The controller must be reset (e.g., by powering-off then on again, by executing "Reset This
Controller" via LCD interface, etc.) for this to take effect.