First Virtual Communications Voyager 3000 User Manual

Page 49

Advertising
background image

RAID Controller Configuration

4-7

Select Terminal (VT100) mode if following the instructions above and press

e. This will

display the screen shown in Figure 4-11.

In the example shown the physical configuration consists of a single tower with 6 disk drives.
The first task is to create a RAID set which is a logical drive as far as the host is concerned.
This logical drive will appear as a normal disk to the Operating System and will behave
similar to any other disk with the added benefits of enhanced reliability and performance.
Prior to creating the RAID set, verify that the configuration as seen by the RAID controller

Figure 4-10 Initial Screen

Figure 4-11 Main Menu Screen

Advertising