First Virtual Communications Voyager 3000 - Manual (Page 65)

Chapter Five
Front Panel Operation
The VOYAGER 3000 includes default configurations that it proposes based on the number
and location of the drives installed. During first time installation, we advise that you use these
default configurations provided by the Quick Installation function. This will allow you to
immediately verify if the system is working. Further optimisation can then be made later on.
Note: The quick set-up assumes that there is only
one host system and that it is connected to channel
0.
1 Press ENT for two seconds.
Quick Logical
Drive Install ..
2 Press ENT. The LCD will display the number of
drives and the first possible
Set TDRV=4 with
LG Level RAID5 ?
RAID level
3 Press t or s to select the RAID level then press ENT
for two seconds. The controller
Init please wait
controller will then start initialization.
The RAID levels available are as follows:
1 Drive = NRAID (Disk Spanning)
2 Drives = RAID0 or RAID1
>2 Drives = RAID0
RAID1 + Spare
RAID3
RAID5
4 The LCD will display the logical drive information
after completing initialization.
LG=0 RAID5 DRV=5
4008M FL=0 SB=0
Press ENT to confirm.
Creating a New Logical Drive
1 Press ENT for two seconds for the Main Menu.
Quick Logical
Drive Install ..