First Virtual Communications Voyager 3000 - Manual (Page 32)

Voyager 3000 User Guide
2-12
•
Use 72-pin 60 Ns DRAM or EDO SIMM.
•
Maximum DRAM size is 32 MBytes in one 32 MByte SIMM.
Installation of SIMMs is accomplished by the following steps:
1. Power off the system and disconnect the power connector.
2. Refer to Figure 2-13 Insert the DRAM SIMM vertically with the key to the left (1). Then,
push towards the back until the hooks on both sides of the socket snap into place (2) as shown
below.
Advanced Cooling Modules
The Advanced Cooling Modules are accessed from the rear of the cabinet. The ACMs are
supplied as complete units. Do not attempt to disassemble beyond the FRU level. To remove
an ACM perform the following sequence of steps:
1.Remove the back face plate by removing the two lower Philips head screws as shown in
Figure 2-14.
Figure 2-13 Installing SIMMs
Figure 2-14 Removing the back face plate