Setting the scsi channels – First Virtual Communications Voyager 3000 User Manual
Page 68
Voyager 3000 User Guide
5-4
Deleting a Logical Drive
1
Press ENT for two seconds for the Main Menu.
2
Press t or s to select View and Edit Logical Drives
and press ENT.
View and Edit
Logical Drives..
3
Press t or s to select logical drive and press ENT.
LG=0 RAID5 DRV=5
4008M FL=0 SB=0
4
Press t or s to select Delete? LG=x and press ENT
for two seconds.
Delete? LG=0
Setting the SCSI Channels
This section includes instructions on setting the following parameters:
SCSI ID
Channel mode (host or drive)
Deleting a LUN definition
1
Press ENT for two seconds for the Main Menu.
2
Press t or s to select View and Edit SCSI Channels
and press ENT.
View and Edit
SCSI Channels ..
3
Press t or s to select channel and press ENT.
CHL 0=Host ID=0
SXF=10M
Example showing:
CHL 0
Channel 0
=Host
Set as host interface
SXF=10M 10 MBps transfer rate
4
To set the SCSI channel ID, press t or s to select Set
SCSI Channel ID and
Set SCSI
Channel ID ..
press ENT for 2 seconds
Press t or s to select the ID number and press ENT.
Redefine? CHL=0
ID=0 to ID:0
The controller must be reset (e.g., by powering-off then on again, by executing "Reset This
Controller" via LCD interface, etc.) for this to take effect.