First Virtual Communications Voyager 3000 - Manual (Page 64)

Voyager 3000 User Guide
4-22
If an EMU is installed in the system it is necessary, before firmware download, to set the
EMU in passive mode by holding down the reset button on the EMU while you power up the
system. After the firmware download re-power the system to reset the EMU.
View System Information
From the Main Menu select View System Information. This option gives the user general
information about the system as shown in Figure 4-40.
Quick Installation
This option is used to create a controller default RAID set, in our example with 6 drives we
will generate a RAID 5 set with a spare drive.
Firstly select Quick Installation from the Main Menu and answer YES to the prompt.
The system will then prompt for a RAID level. In this example we will select RAID level 5 +
Spare as shown in Figure 4-41.
After this the system will commence building a RAID set and will automatically map the
logical drive to LUN 0 of the first host channel.
Figure 4-40 View system information
Figure 4-41 Quick Installation