First Virtual Communications Voyager 3000 User Manual

Page 61

Advertising
background image

RAID Controller Configuration

4-19

4. Sync Transfer Clock: this option allows the user to adjust the transfer rate of

synchronous data transfers along the bus or to select the asynchronous mode of
operation.

5. Wide Transfer: this option allows the user to enable or disable wide transfer mode.
6. View and Edit SCSI Target: when this option is selected a screen similar to that in

Figure 4-37 is presented.

By using the Up and Down Arrow keys the user may scroll down to ID 15.
Select an ID to be viewed by highlighting it and pressing

e on it. The following options

are presented:

1. Slot number
2. Maximum Sync. Xfer Clock
3. Maximum Xfer Width
4. Parity Check
5. Disconnect Support
6. Maximum Tag Count
7. Resume to Default Settings

1. Slot Number: this option allows the user to assign a slot number to the drive in the ID

chosen.

2. Maximum Sync. Xfer Clock: this option allows the user to set the maximum

synchronous transfer speed in 4ns units.

3. Maximum Xfer Width: this option allows the user to set the maximum transfer width for

data at either narrow or wide.

4. Parity Check: this option allows the user to enable or disable parity checking.
5. Disconnect Support: this option allows the user to enable or disable target disconnect
6. Maximum Tag Count: this option allows the user to set the desired maximum tag count.
7. Resume to Default Settings: this option allows the user to restore the default settings for

the selected ID. Figure 4-37 shows the default settings for the Voyager 3000 system.

Figure 4-37 View and edit SCSI target

Advertising