First Virtual Communications Voyager 3000 - Manual (Page 31)

Installation and Setup
2-11
Access to the controller is obtained by removing the four screws at the side of the top panel.
This will allow access to the main board. Removing the piggy-backed channel cards reveals
the topography of the main board as shown in Figure 2-12.
SIMM Installation
Note the following guidelines with regards to DRAM:
•
Minimum DRAM required is 4 MBytes installed in SIMM socket
•
EDO RAM is recommended for enhanced performance.
Figure 2-11 RAID Controller
Figure 2-12 Main board access
Power
Socket
Channel 0
CPU
Simm
Module