FUJITSU ServerView Virtual-IO Manager V3.1 - Manual (Page 171)

100 Mbit/s
100 Mbit/s full-duplex.
By default, Auto negotiation is selected.
Service VLAN id
A Service VLAN ID must be specified.
IGMP Snooping
If IGMP Snooping is activated, the connection blade controls whether
requests to join a multicast group occur at the downlink ports of an uplink
set. If necessary, the corresponding downlink ports may be added to the
forwarding table of this multicast group or removed again.
The IGMP Snooping option is selected by default.
Ports for the uplink set (change with right click)
Assign the required ports of the IBP to the uplink set. To do this, open
the context menu of each relevant port. If an uplink set for a switch stack
is defined, the uplink ports of all IBPs belonging to the stack are shown
one below the other. Use the scroll bar to reach the uplink ports of
another stack member.
The context menu can contain the following menu items:
Add
Only activated if the port is not yet assigned to the uplink set.
Assigns the port to the uplink set. If the port is already assigned to
another uplink set, this assignment is deleted.
Add as Backup
Only activated if the port is not yet assigned to the uplink set.
Assigns the port as a backup port to the uplink set. If the port is
already assigned to another uplink set, this assignment is deleted.
Remove
Only available if the port is already assigned to the uplink.
Removes the port assignment from the uplink set.
ServerView Virtual-IO Manager 171
5.4 Wizards