FUJITSU ServerView Virtual-IO Manager V3.1 - Manual (Page 202)

5 Virtual-IO Manager user interface
Enable DCB Settings
This option is available only for FCoE and iSCSI functions. It enables
the DCB (Data Center Bridging) feature of the connection blade. The
DCB settings here are specific configuration settings in a DCB-enabled
switching device.
This option should be enabled if the profile will be used in a blade server
chassis where the corresponding physical CNA port will be connected to
a PY CB Eth Switch/IBP 10 Gb 18/8 (SBAX2) connection blade in IBP
mode.
If the port of the server blade, where the profile will be used, is connected
to a LAN pass-thru module or a PY CB Eth Switch/IBP 10 Gb 18/8
(SBAX2) connection blade in switch mode, the option Enable DCB set-
tings should not be set.
Priority Level
The priority level. Possible values are 0 to 7; for FCoE this is by default
the value 3, for iSCSI the default value is 4.
5.4.3.6 Virtual Addresses step (Create Server Profile wizard)
Virtual Addresses is the next step in the Create Server Profile wizard. In
this step, you specify the virtual addresses for each port. It is only shown if
Use virtual addresses is activated in the IO-Channels step of the Create
Server Profile wizard.
202 ServerView Virtual-IO Manager