FUJITSU ServerView Virtual-IO Manager V3.1 - Manual (Page 57)

3 Installation and uninstallation
You can install the Virtual-IO Manager on a central management station
(CMS) under Windows or Linux (see section
"Installing the Virtual-IO Man-
ager on a Windows-based CMS" on page 58 and "Installing the Virtual-IO
Manager on a Linux-based CMS" on page 73 ).
Please check first the requirements for installing the Virtual-IO Manager on
CMS (see section
"Prerequisites for the VIOM installation" on page 57 ).
If a previous version is already installed on the management station, an
update installation runs automatically when you install the new version. All
previous VIOM configurations and definitions remain the same (see section
"Updating the Virtual-IO Manager on a Windows-based CMS" on page 72 )
and "Updating the Virtual-IO Manager on a Linux-based CMS" on page 89 .
If you want to use the command line interface of the Virtual-IO Manager
(VIOM CLI), you must install the VIOM CLI software package. You will find
details on how to install and use VIOM CLI in the "Virtual-IO Manager Com-
mand Line Interface" manual.
3.1 Prerequisites for the VIOM installation
The requirements for installing the Virtual-IO Manager on a central man-
agement station are as follows:
l
Operating system for the central management station
o Microsoft Windows® Server
TM
2003 all editions
o Microsoft Windows® Server
TM
2003 R2 all editions
o Microsoft Windows® Server
TM
2008 all editions
o Microsoft Windows® Server
TM
2008 R2 all editions
o Linux Novell (SLES10): SP2 and SP3
o Novell (SLES 11): SP1 and SP2
o Red Hat RHEL 5.6/5.7/5.8
o Red Hat RHEL 6, 6.1/6.2
ServerView Virtual-IO Manager 57