Furuno FR1500 Mk3 - Manual (Page 45)

4-13
5. Unfasten eight screws to remove the cover.
6. Fasten the RP-17 Board with five panhead screws.
7. Connect the cable assy. between J106 on the SPU Board and J4 on the RP
Board. Attach toroidal core to cable assy. and fasten cable assy. with cable
tie.
RP Board
03P9259A
Panhead Screw
M3X8 (5 pcs.)
Cable Assy.
03S9456
J4
P4
J1
FRONT PANEL
Cable Tie
CV-150
Toroidal Core
TFC-25-15-12
RP Board
SPU chassis
SPU Board
03P9230
J4
J106
A
B
SPU Chassis
Square Bushing
Chassis
J4
RP Board
03P9259A
Toroidal Core
Exploded View from B
LEFT SIDE
TOP VIEW
Face notch upward.
Connector for Autopilot
Inside
Cable Tie
Toroidal Core
Cable Assy.
Exploded View from A
Figure 4-13 Display unit, left side view
8. If applicable, connect autopilot to J1 with an XH connector (5P). Solder and
wire the cable as shown in Figures 4-14 and 4-15.
From Autopilot
J103
J105
J104
J214
J102
SPU Board
03P9230
J101
Attach clamp
(supplied) and
pass through
clamp.
A Pass through
clamp.
Solder
From J1
Square
Hole
Figure 4-14 Display unit, top view