Furuno FR1500 Mk3 - Manual (Page 50)

5-1
INITIALIZATION AND ADJUSTMENT
5.1 Opening the Installation Menus
The display unit RDP119 can be used as a sub display. If the sub display is
installed, set heading alignment, sweep timing, video signal level, antenna height
and STC slope for each display unit. Most adjustments are done on the INSTAL-
LATION SETUP menu. This menu is normally locked to prevent adjustment. Open
the menu as follows:
1. Turn off the power.
2. Turn on the power while pressing and holding down the GAIN control.
3. Press the [MENU] key to display the main menu.
4. Press the [0] key four times.
5. Press the [5] key twice to select INSTALL.
6. Press numeric keys to select item and set option.
The complete installation menus appear below.
SET UP 1
1. ↑
2. HDG ADJ 0.0
°
3. TIMING 0.044NM
4. VIDEO LEVEL AUTO MAN
5. MBS-T 000
6. MBS-L 000
7. ANT H 5m 7.5m 10m
15m 20m 30m
8. STC SLOPE SLOW MID FAS
9. ALM LEVEL LOW MID HIGH
0.
↓
SET UP 2
1.
↑
2. LOG RATE 0200
3. HDG SNSR GYRO MAG OFF
4. KEY BEEP OFF ON
5. HU TB OFF ON
6. VIDEO NORMAL QV
7. OS & ANT
8. BLIND SCTR
9. TUNE SET
0.
↓
OS & ANT
1.
↑
2. LENGTH 000m
3. WIDTH 00m
4. FORE (RDR) 000m
5. PORT (RDR) 000m
6. FORE (GPS) 000m
7. PORT (GPS) 00m
BLIND SECTOR
1.
↑
2. FROM 180
°
SECTOR 000
°
3. FROM 180
°
SECTOR 000
°
OTHER
1.
↑
2. ECHO AVG OFF ON
3. TX/ANT ROTATE STOP
4. ON TIME 000000.0H
5. TX TIME 000000.0H
6. RNG UNIT* NM KM SM
[0] key
[7] key
[0] key
[8] key
[MENU], [0] four times, [5] twice
* R-type radar only.
Figure 5-3 Installation menus
Default settings are
cir/cumscribed.