Furuno FR1500 Mk3 - Manual (Page 56)

5-7
5.8 Other Items on the Installation Menus
SET UP 1 menu
Keying sequence: [MENU] [0] [0] [0] [0] [5] [5]
2. HDG ADJ: Aligns heading.
3. TIMING: Adjusts sweep timing.
4. VIDEO LEVEL: Adjusts video amplifier level automatically or manually.
5., 6. MBS-T, MBS-L: Suppresses main bang in level and timing
7. ANT H: Enter height of scanner above water. Select from 5 m, 7.5 m, 10 m, 15
m, 20 m, or more than 30 m. Set height of scanner for both main display and sub
display (if installed).
8. STC SLOPE: Selects level of STC affect; Slow, Medium or Fast.
Set STC slope for both main display and sub display (if
installed).
9. ALM LEVEL: Select echo strength which triggers the guard zone alarm.
SET UP 2 menu
Keying sequence: [MENU] [0] [0] [0] [0] [5] [5] [0] [0]
2. LOG RATE: Enter speed log’s pulse rate.
3. HDG SNSR: Select source of heading data; gyrocompass, magnetic compass
or OFF (no heading data).
4. KEY BEEP: Turns key beep on/off.
5. HU TB: Enables/disables the heading up true bearing presentation mode.
6. VIDEO: Set to NORMAL (analog signal) for normal use. Select QV (Quantized
Video) to adjust ATA (Automatic Tracking Aid ARP-17 required).
7. OS & ANT: See OS & ANT menu.
8. BLIND SCTR: Sets area (up to 2) where no radar pulses will be transmitted.
For example, set the area where an interfering object at the rear of the scanner
would produce a dead sector (area where no echoes appear) on the display. To
enter an area, select ON and enter relative bearing range of the area.
9. TUNE SET: Tunes the radar receiver.
OTHER menu
Keying sequence: [MENU] [0] [0] [0] [0] [5] [5] [0] [0] [0]
2. ECHO AVG: Echo averaging can be turned on without gyrocompass connec-
tion.
3. TX/ANT: Set to ROTATE in normal use. STOP enables transmission state
without scanner rotation.