Frymaster ELECTRIC SERIES OCF30 - Manual (Page 16)

3–4
3.3.2 Routine Oil Changes
When the oil reservoir level is low, the controller displays TOPOFF OIL EMPTY in the left display
and CONFIRM in the right display. Press S (CONFIRM). Some procedures may differ from photos
shown. Follow manufacturer’s instructions for changing the JIB. If using solid shortening see Appendix B
in the rear of this manual for instructions.
1. Open the cabinet and slide the JIB
from the cabinet (see Figure 4).
Figure 4
2. Remove the cap and pour any remaining oil in the
container into all fry vats equally (see Figure 5).
Figure 5
3. With the jug upright remove the cap
and foil seal (see Figure 6).
Figure 6
4. Put the tube in the new full container (see Figure 7).
Figure 7
5. Slide the JIB onto the shelf inside the fryer cabinet (as
seen in Figure 4).
6. Press and hold the orange JIB reset switch three (3)
seconds to reset the top off system
(see Figure 8).
Figure 8
Image and location may differ from photo.
3.3.3 Bulk Oil Systems
Instructions for installing and using bulk oil systems are found in Appendix C located
at the rear of this manual.
WARNING:
Do not add HOT or
USED oil to a JIB.