Frymaster ELECTRIC SERIES OCF30 - Manual (Page 31)

6-4
6.2.4 Filtration Problems
Problem Probable Causes Corrective Action
Fryer filters after each
cook cycle.
Filter prompt setting incorrect.
Change the filter prompt setting.
Filter menu functions
won’t start.
Temperature too low.
Ensure fryer is at setpoint before starting;
ensure the controller is ON.
Controller displays
WAIT FOR FILTER.
Another function is still in process.
Wait until the previous function ends to
start another filtration cycle.
Filter pump won't start
or pump stops during
filtering.
A. Power cord is not plugged in or circuit
breaker is tripped.
B. Pump motor has overheated causing
the thermal overload switch to trip.
C. Blockage in filter pump.
A. Verify that the power cord is fully
plugged in and the circuit breaker is
not tripped.
B. If the motor is too hot to touch for
more than a few seconds, the
thermal overload switch has
probably tripped. Allow the motor
to cool at least 45 minutes then press
the Pump Reset Switch. (See page 5-
4)
C. Call your FAS for assistance.
Filter Pump runs, but
oil return is very slow.
Improperly installed or prepared filter pan
components or cold oil.
Remove the oil from the filter pan and
replace the filter paper, ensuring that
the filter screen is in place under the
paper.
Verify that O-rings are present and in
good condition on filter pan connection
fitting.
Controller displays
OIL IN DRAIN
PAN / CONFIRM
Drain valve open or possibility that oil is in
drain pan.
Press S (CONFIRM) and follow
directions for
FILL VAT FROM
DRAIN PAN.
6.2.5 Auto Top-Off Problems
Problem Probable Causes Corrective Action
Frypots top off cold. Incorrect setpoint. Ensure setpoint is correct.
Frypots won’t top off.
A. Fryer temperature too low.
B. Oil is too cold.
C. JIB out of oil
D. Service required error exists
A. Fryer temperature must be at
setpoint.
B. Ensure that the oil in the JIB is
above 70°F (21°C).
C. Ensure the JIB is not out of oil and
supply line is in the JIB. Replace JIB
and press the S button when
prompted to reset top off system.
If problem persists call your FAS for
assistance.
D. Call your FAS for assistance.
One vat doesn’t top off.
A. Filter error exists.
B. Service required error exists
C. Solenoid, pump, pin issue, RTD or
ATO issue.
A. Clear filter error properly. If
problem persists call your FAS for
assistance.
B. Call your FAS for assistance.
C. Call your FAS for assistance.