To add ip pools to a virtual, To add virtual ips to a virtual, To add firewall addresses to a virtual domain – Fortinet 100A User Manual

Page 139: To add ip pools to a virtual domain, To add virtual ips to a virtual domain

Advertising
background image

System virtual domain

Configuring firewall policies for a virtual domain

FortiGate-100A Administration Guide

01-28007-0068-20041203

139

6

Select Create new to add firewall policies to the current virtual domain.
See

“Policy” on page 190

. You can only add firewall policies for the physical

interfaces, VLAN subinterfaces, or zones added to the current virtual domain. The
firewall policies that you add are only visible when you are viewing the current virtual
domain. Network traffic accepted by the interfaces and VLAN subinterfaces added to
this virtual domain is controlled by the firewall policies added to this virtual domain

To add firewall addresses to a virtual domain

The following procedure applies to NAT/Route and Transparent mode.

1

Go to System > Virtual domain > Virtual domains.

2

Select Change following the current virtual domain name above the table.

3

Choose the virtual domain for which to configure firewall addresses.

4

Select OK.

5

Go to Firewall > Address.

6

Add new firewall addresses, address ranges, and address groups to the current virtual
domain. See

“Address” on page 198

.

To add IP pools to a virtual domain

The following procedure applies to NAT/Route mode.

1

Go to System > Virtual domain > Virtual domains.

2

Select Change following the current virtual domain name above the table.

3

Choose the virtual domain for which to configure firewall IP pools.

4

Select OK.

5

Go to Firewall > IP Pool.

6

Add new IP pools as required for the current virtual domain. See

“IP pool” on

page 219

.

To add Virtual IPs to a virtual domain

The following procedure applies to NAT/Route mode.

1

Go to System > Virtual domain > Virtual domains.

2

Select Change following the current virtual domain name above the table.

3

Choose the virtual domain for which to configure virtual IPs.

4

Select OK.

5

Go to Firewall > Virtual IP.

6

Add new virtual IPs as required for the current virtual domain. See

“Virtual IP” on

page 214

.

Advertising