Fortinet 100A - Manual (Page 62)

62
01-28007-0068-20041203 Fortinet Inc.
Routing table list System network
Routing table (Transparent Mode)
In Transparent mode, you can configure routing to add static routes from the FortiGate
unit to local routers.
Routing table list
Figure 12: Routing table
Transparent mode route settings
Figure 13: Transparent mode route options
To add a Transparent mode route
1 Go to System > Network > Routing Table.
2 Select Create New to add a new route.
3 Set the Destination IP and Mask to 0.0.0.0.
For the default route, set the Destination IP and Mask to 0.0.0.0.
Create New Select Create New to add a new route.
#
Route number.
IP The destination IP address for this route.
Mask The netmask for this route.
Gateway The IP address of the next hop router to which this route directs traffic.
Distance The the relative preferability of this route. 1 is most preferred.
Delete icon. Select to remove a route.
View/edit icon. Select to view or edit a route.
Move To icon. Select to change the order of a route in the list.
Destination IP
/Mask Enter the destination IP address and netmask for this route.
Gateway Enter the IP address of the next hop router to which this route directs traffic
Distance The the relative preferability of this route. 1 is most preferred.
Note: Only one default route can be active at a time. If two default routes are added to the
routing table, only the default route closest to the top of the routing table is active.