Fortinet 100A - Manual (Page 35)

System status Reverting to a previous firmware version
FortiGate-100A Administration Guide 01-28007-0068-20041203
35
Where <name_str> is the name of the firmware image file and <tftp_ip> is the IP
address of the TFTP server. For example, if the firmware image file name is
FGT_300-v280-build183-FORTINET.out and the IP address of the TFTP server
is 192.168.1.168, enter:
execute restore image FGT_300-v280-build183-FORTINET.out
192.168.1.168
The FortiGate unit responds with the message:
This operation will replace the current firmware version!
Do you want to continue? (y/n)
6 Type y.
The FortiGate unit uploads the firmware image file, upgrades to the new firmware
version, and restarts. This process takes a few minutes.
7 Reconnect to the CLI.
8 To confirm that the new firmware image is successfully installed, enter:
get system status
9 Use the procedure “To update antivirus and attack definitions” on page 120 to update
antivirus and attack definitions, or from the CLI, enter:
execute update_now
Reverting to a previous firmware version
Use the following procedures to revert your FortiGate unit to a previous firmware
version.
Reverting to a previous firmware version using the web-based
manager
The following procedures revert the FortiGate unit to its factory default configuration
and deletes IPS custom signatures, web content lists, email filtering lists, and changes
to replacement messages.
Before beginning this procedure you can:
• Back up the FortiGate unit configuration.
• Back up the IPS custom signatures.
• Back up web content and email filtering lists.
For information, see “Backing up and Restoring” on page 116 .
If you are reverting to a previous FortiOS version (for example, reverting from FortiOS
v2.80 to FortiOS v2.50), you might not be able to restore the previous configuration
from the backup configuration file.
To revert to a previous firmware version using the web-based manager
1 Copy the firmware image file to the management computer.
Note: Installing firmware replaces the current antivirus and attack definitions with the definitions
included with the firmware release that you are installing. After you install new firmware, use the
procedure
“To update antivirus and attack definitions” on page 120 to make sure that antivirus
and attack definitions are up to date.