Fortinet 100A - Manual (Page 270)

270
01-28007-0068-20041203 Fortinet Inc.
ipsec phase1 VPN
Example
Use the following command to edit an IPSec VPN phase 1 configuration with the
following characteristics:
• Phase 1 configuration name: Simple_GW
• Remote peer address type: Dynamic
• Encryption and authentication proposal: des-md5
• Authentication method: psk
• Pre-shared key: Qf2p3O93jIj2bz7E
• Mode: aggressive
• Dead Peer Detection: enable
• Long idle: 1000
• Short idle: 150
• Retry count: 5
• Retry interval: 30
config vpn ipsec phase1
edit Simple_GW
set Type dynamic
set proposal des-md5
set authmethod psk
set psksecret Qf2p3O93jIj2bz7E
set mode aggressive
set dpd enable
set dpd-idlecleanup 1000
set dpd-idleworry 150
set dpd-retrycount 5
set dpd-retryinterval 30
end
dpd-retrycount
<retry_integer> The DPD retry count when dpd is set to
enable. Set the number of times that the
local VPN peer sends a DPD probe before
it considers the link to be dead and tears
down the security association (SA). The
dpd-retrycount range is 0 to 10.
To avoid false negatives due to congestion
or other transient failures, set the retry
count to a sufficiently high value for your
network.
3 All models.
dpd must
be set to
enable.
dpd-retryinterval
<seconds_integer> The DPD retry interval when dpd is set to
enable. Set the time, in seconds, that the
local VPN peer waits between sending DPD
probes. The dpd-retryinterval range
is 1 to 60.
5
seconds
All models.
dpd must
be set to
enable.
ipsec phase1 command keywords and variables (Continued)
Keywords and
variables Description Default Availability