Management, To add a zone” on – Fortinet 100A User Manual
Page 59
System network
Zone settings
FortiGate-100A Administration Guide
01-28007-0068-20041203
59
To add a zone
1
If you have added a virtual domain, go to System > Virtual Domain > Current
Virtual Domain and select the virtual domain to which you want to add the zone.
2
Go to System > Network > Zone.
3
Select Create New.
4
In the New Zone dialog box, type a name for the zone.
5
Select the Block intra-zone traffic check box if you want to block traffic between
interfaces or VLAN subinterfaces in the same zone.
6
Select the names of the interfaces or VLAN subinterfaces to add to the zone.
7
Select OK.
To delete a zone
You can only delete zones that have the Delete icon beside them in the zone list.
1
If you have added a virtual domain, go to System > Virtual Domain > Current
Virtual Domain and select the virtual domain from which to delete the zone.
2
Go to System > Network > Zone.
3
Select Delete to remove a zone from the list.
4
Select OK to delete the zone.
To edit a zone
1
If you have added a virtual domain, go to System > Virtual Domain > Current
Virtual Domain and select the virtual domain in which to edit the zone.
2
Go to System > Network > Zone.
3
Select Edit to modify a zone.
4
Select or deselect Block intra-zone traffic.
5
Select the names of the interfaces or VLAN subinterfaces to add to the zone.
6
Clear the check box for the names of the interfaces or VLAN subinterfaces to remove
from the zone.
7
Select OK.
Management
Configure the management interface in Transparent mode to set the management IP
address of the FortiGate unit. Administrators connect to this IP address to administer
the FortiGate unit. The FortiGate also uses this IP address to connect to the FDN for
virus and attack updates (see
).
You can also configure interfaces to control how administrators connect to the
FortiGate unit for administration. See
“To control administrative access to an interface”
.