Config, 295 config – Fortinet 100A User Manual
Page 295
Antivirus
Config
FortiGate-100A Administration Guide
01-28007-0068-20041203
295
Config
Go to Config to set quarantine configuration options including whether to quarantine
blocked or infected files and from which service. You can also configure the time to
live and file size values, and enable AutoSubmit settings.
Figure 156:Quarantine configuration
Quarantine configuration has the following options:
Options
Quarantine Infected Files: Select the protocols from which to quarantine
infected files identified by antivirus scanning.
Quarantine Suspicious Files: Select the protocols from which to quarantine
suspicious files identified by heuristics.
Quarantine Blocked Files. Select the protocols from which to quarantine
blocked files identified by antivirus file blocking. The Quarantine Blocked
Files option is not available for HTTP or FTP because a file name is blocked
before downloading and cannot be quarantined.
Age limit
The time limit in hours for which to keep files in quarantine. The age limit is
used to formulate the value in the TTL column of the quarantined files list.
When the limit is reached the TTL column displays EXP. and the file is
deleted (although a record is maintained in the quarantined files list).
Entering an age limit of 0 (zero) means files are stored on disk indefinitely
depending on low disk space action.
Max filesize to
quarantine
The maximum size of quarantined files in MB. Setting the maximum file size
too large may affect performance.
Low disk space Select the action to take when the local disk is full: overwrite the oldest file or
drop the newest file.
Enable
AutoSubmit
Enable AutoSubmit: enables the AutoSubmit feature. Select one or both of
the options below.
Use file pattern: Enables the automatic upload of files matching the file
patterns in the AutoSubmit list.
Use file status: Enables the automatic upload of quarantined files based on
their status. Select either heuristics or block pattern.
Heuristics is configurable through the CLI only. See
Apply
Select Apply to save the configuration.