GCC Printers 16 - Manual (Page 23)

GCC Elite Color 16 Series User’s Guide 1-3
Positioning the Printer
When using an ultrasonic water vaporizer
Using tap or well water with ultrasonic water vaporizers disperses impurities into the air. These
impurities can accumulate inside the printer and cause print quality to deteriorate. If you install
the printer in the same room as an ultrasonic water vaporizer, use only filtered water in the
water vaporizer.
Minimum Installation Clearances
Be sure to install the printer in a location that respects the minimum clearances indicated in the
illustrations below.
Top View
Front View
CAUTION: To avoid obstruction of the ventilation grills on the back and the side of the printer,
position the printer no less than 6 in. (150 mm) from the wall on the right side, 4 in. (100 mm)
from the wall on the left side, and 8 in. (200 mm) from the wall at the back. Obstructing the
ventilation grills can cause the printer to overheat and become a fire hazard. To allow easy rou-
tine maintenance, replacement of consumables, proper operation and ensure satisfactory per-
formance, confirm that the printer’s position is as illustrated below.
4” (100mm) 8” (200mm)
6 “ (150mm)
24” (600mm)
4” (100mm) 6” (150mm)