Multi-Tech Systems ISI5634PCI/4/8 - Manual (Page 33)

33
Chapter 3—Software/Driver Installation
Installing the ISI5634PCI Card in Windows NT 3.51/4.0
The following procedure describes how to install the ISI5634PCI in a
system operating Microsoft Windows NT 3.51 or 4.0 for use with
Remote Access Service (RAS) server and other communications/fax
server type applications. These procedures apply to both 3.51 and 4.0.
1. Turn off the PC.
2. Install the ISI5634PCI card in an available PCI expansion slot in
the computer. Follow the computer manufacturer's instructions
concerning installation of expansion cards. Observe standard
precautions regarding electro-static discharge (ESD) when
handling the ISI5634PCI board (the board should be kept in its
shipping bag until used). During installation, handle the
ISI5634PCI circuit card by its edges and keep one hand in contact
with the PC chassis.
3. Turn on the PC and start Windows NT.
4. Insert the ISI driver CD-ROM into the CD-ROM drive (if drivers
have been downloaded from the MultiTech web site, they will
typically be on diskette; in that case, insert diskette into floppy
drive).