Multi-Tech Systems ISI5634PCI/4/8 - Manual (Page 52)

52
ISI5634PCI/4/8 User Guide
If you have downloaded the ISI driver from the MultiTech web site
onto a diskette, use this command:
COPY A:\NOVELL\AIOISIX.NLM F:\SYSTEM
To load the driver, go to the system or PC console (where the ISI card
is installed) and enter the following at the prompt:
LOAD AIOISIX
[port=
W
] [interrupt=
X
] [name=
Y
] [note=
Z
]
Because the ISI5634PCI models are PCI-bus cards, Netware will set up
the interrupt (IRQ) and I/O address automatically.
To install the ISI card scripts, copy aiomdms.mdc to
f:\system\aio\directory. Click Yes to overwrite the existing
aiomdms.mdc file.
Configuring Ports for NetWare Connect
When the driver is installed, it will allocate consecutive ports for the
ISI card as follows:
• 8 consecutive ports for the ISI5634PCI-8
• 4 consecutive ports for the ISI5634PCI-4
To set up NetWare Connect ports, enter LOAD NWCCON at the
NetWare console prompt. LOAD NWCCON opens the NetWare
Connect Configuration Utility. Select the appropriate menu options
(modem type, speed, flow control, etc.).
Removing the Driver (Novell)
In Novell, remove file AIOISIX.NLM from the system directory and
make the appropriate changes to the Autoexec.ncf file.
SCO Open Server 5 Driver Installation
The ISI driver for SCO Open Server 5 is shipped on CD-ROM (FAT file
system) and can also be downloaded from the Multi-Tech web site. In
both cases, the driver files are compressed (“tarred”). Users installing
from the CD-ROM should begin at “To install from CD-ROM” directly
below. Users installing from a floppy disk should skip down to “To
install driver from floppy disk” later in this section. The filename of the
SCO5 driver in its tarred form is sco50x.tar.