Multi-Tech Systems ISI5634PCI/4/8 - Manual (Page 96)

96
ISI5634PCI/4/8 User Guide
S5 decimal 0–32 8 (^H) Sets ASCII code for the backspace
33–127 character. Values greater than 32
disable backspace.
S6 seconds 2–65* 2* Sets time the modem waits after it goes
off-hook before it begins to dial the
telephone number.
S7 seconds 1–255* 50* Sets time the modem waits for a carrier
signal before aborting a call. Also sets
wait for silence time for the @ dial
modifier.
S8 seconds 0–65 2 Sets length of a pause caused by a
comma character in a dialing command.
S9 decimal 0, 1–127 37 (%) Sets ASCII code for remote
configuration escape character. S9=0
disables remote configuration.
S10 100 ms 1–254 20 Sets how long a carrier signal must be
lost before the modem disconnects.
S11 1 ms 50–150* 95* Sets spacing and duration of dialing
tones.
S28 decimal 0, 1–255 1 0 disables, 1–255 enables V.34
modulation.
S30 1 minute 0, 1–255 0 Sets length of time the modem waits
before disconnecting when no data is
sent or received. Value of zero disables
the timer. See also the \T command
S35 decimal 0–1 0 0 disables, 1 enables the V.25 data calling
tone, which allows remote data/fax/
voice discrimination.
S36 decimal 0–7 7 Specifies the action to take in the event
of a negotiation failure when error
control is selected. (See S48.)
S37 decimal 0–19 0 Sets maximum V.34 upstream speed at