Minolta PAGEWORKS 20 - Manual (Page 148)

7-10
Ch
ap
te
r 7
Spec
ifications
Be sure to use only a parallel interface cable that meets the specifi-
cations described below.
Length:
Less than 5 feet (1.5 meters)
Connectors:
Printer: Centronics 36-pin connector
Computer: EIA 25-pin connector
Cable type:
Shielded type. Each signal and ground pair should be twisted.
IEEE 1284 type-B connector pin assignments
NOTE
Minolta does not warrant the use of any particular cable. The user
assumes all responsibility as to the quality and performance of the
cable.
5. Interface Connector and Cable
Spec7.frm 10 ページ ２００３年１１月１８日 火曜日 午前９時５３分