Minolta PAGEWORKS 20 - Manual (Page 46)

2-16
Ch
apt
er
2
Setting Up
You can connect the printer to your computer using the printer’s par-
allel ports. For more information, see “Specifications” page 7-10.
IMPORTANT
You must purchase an IEEE 1284 type-B cable. If you try
to use any other cable, you may damage the printer’s port.
NOTE
Always use a shielded interface cable. Use of an
unshielded cable can result in radio interference with data.
Interface Port
1. Make sure that the power switch
of the computer and printer is
turned off.
2. Connect one end of the interface
cable to the printer port of the
computer.
3. Then connect the other end of the
interface cable to the interface
connector on the backside of the
printer.
7. Connecting the Interface Cable
PRINTER
Parallel Port
IBM PC AT or
compatible
Centronics 36-pin connector
EIA 25-pin connector
Setting2.frm 16 ページ ２００３年１１月１８日 火曜日 午前９時５２分