Minolta PAGEWORKS 20 - Manual (Page 32)

2-2
Ch
apt
er
2
Setting Up
NOTES
•
Use a power source with minimal voltage and frequency fluctu-
ation.
•
Only use an outlet that is rated for the voltage capacity specified
for this printer.
•
Be sure to plug the power cord all the way into the outlet. The
outlet should be located near the printer and easily accessible so
you can unplug the power cord immediately should any problem
occur.
•
Make sure that the outlet is visible, and not hidden behind the
printer or any other object.
•
If any other electrical equipment is plugged into the same outlet,
make sure that the capacity of the outlet is not exceeded.
•
If you use an extension cord, make sure its capacity is greater
than the power consumption of the printer. Using an extension
cord with a lower capacity creates the danger of fire.
•
Never use a multiple socket to connect other appliances or
machines to the same outlet being used to power the printer.
Grounding
Always ground the printer to guard against the danger of electric
shock. To ground the printer, connect the grounding wire to the
ground terminal of the electrical outlet you are plugging into or to a
grounding contact that complies with local electrical standards in
your area.
Contact your Technical Representative if you are unable to make
grounding connections yourself.
NOTE
Never connect the grounding wire to a gas pipe, the
grounding wire for a telephone, or a water pipe.
1. Installation Precaution
Setting2.frm 2 ページ ２００３年１１月１８日 火曜日 午前９時５２分