Muratec F-65 - Manual (Page 32)

You can make copies from your fax machine by using either the feeder or the
machine’s memory.
Copying from feeder
Use this mode to make a single copy.
Note: When you make a copy from the feeder, you cannot select the normal resolu-
tion.
To make a copy from feeder:
1 Insert the document face down. Adjust the document guides for a correct fit.
2 Press COPY . The LCD shows:
Note: If you enter the number of copies for each page, the machine automati-
cally switches to memory copy mode (see next column).
3 Press COPY again to begin copying.
Copying from memory
Use this mode to make multiple copies or reduced copies. The copy reduction rate
can be set through the copy parameter settings (see page 2.4).
Note: Your machine automatically sorts multiple copies. For example, four copies
of the same two-page document will print as : 1,2 — 1,2 — 1,2 — 1,2.
To make a copy from memory:
1 Insert the document face down. Adjust the document guides for a correct fit.
2 Press COPY . The LCD shows:
If you want to make one copy of each page of the document from memory,
enter 0, 1 using numeric keypad, then skip to step 4.
If not, go on to step 3.
3 Use the numeric keypad to enter the desired number of copies for each page
in the document. You may choose one (“01”) to 99 copies.
Here, we chose three copies.
Note: The setting requires two digits. Always enter a leading zero for quan-
tities below 10 copies.
4 Press COPY to begin the copying.
Note: In this mode, the documents are stored in the memory before copying.
If the memory of your machine becomes low, a “Memory Over Flow” mes-
sage is displayed on the
LCD and no more documents will be stored. If this
happens, press COPY to print the documents that are already stored in mem-
ory, or press CANCEL to clear all documents stored during this
operation.Dividing a large document into smaller batches will help you
avoid this error.
No. of Copy = 03
No. of Copy = 01
No. of Copy = 01
1.24
Getting started
Making copies