Muratec F-65 - Manual (Page 41)

Beyond the basics
2.6
Setting the language
While English is the language which your machine initially uses to display messages
and print reports, you can set it to “speak” French or Spanish, too!
To make the change from one language to the next, press
PROGRAM , #.
¿Qué es? — or, What is it?
If you aren’t sure which language is showing after you’ve made a language change,
press
PROGRAM once and decide based on what appears on the LCD :
is French.
is Spanish.
If the language you see is the one you want, press STOP to return to standby mode.
If you want to change languages, press STOP to return to standby mode and then
press PROGRAM , # to go to the next language in the cycle.
Printing your settings
After you enter your settings, print a settings list.
With this list, you can quickly check all the settings without having to check them
on the machine.
Note: Please refer to the index at the end of these instructions to locate any set-
ting you do not recognize or understand.
To print the settings list, press PROGRAM , J , 2, 1, ENTER .
Printing a program list
Your machine can also print a program list. This list gives a brief summary of
instructions available on your fax machine, organized in a “program tree” so you
can see which key combinations produce which instructions.
Note: Please refer to the index at the end of these instructions to locate any set-
ting you do not recognize or understand.
To print a program list, press PROGRAM , *, 8. Your machine will print the list.
Núm. Una-Tecla
Num. Une-Touche