Muratec F-65 - Manual (Page 62)

Beyond the basics
2.27
6 Press ENTER . The LCD shows briefly:
then it will show:
7 Enter the fax number either by pressing a one-touch key, entering a speed-
dial number or dialing from the numeric keypad. Do not press
START .
8 What you do now depends upon when you want the transmission to begin.
• To have it begin now, skip to step 11.
• To delay it, proceed to step 9.
9 Press COM - OPTIONS , COM - OPTIONS , ENTER .
The LCD shows the current day and time:
10 Use the numeric keypad to enter the day and time when the transmission
should begin, then press
ENTER .
Note: If you make a mistake, press to move the cursor to the left, or to
move it to the right, to that character. Then re-enter until the number
is just as you want it.
11 Press START .
If you chose an immediate transmission in step 8, your fax machine will begin
dialing. If you chose a delayed command, the machine will display
“
** Reserved ** ” on the LCD , indicating that the machine has stored the
command in memory and will perform it later.
Note: The ITU - T subaddress and password can be up to 20 characters in length and
can include any combination of numbers and the * and # symbols. Do not
include other non-numerical characters).
Note: To change a number you have already entered:
— Press to move the cursor to the left or to move it to the right, to
that character.
— Press CANCEL to erase the character.
— Enter the digit(s) you want.
Time : 15/17:05
_
Enter Fax Number